Garage door screens retractable – Place the door on a flat surface on the inside of the door facing up. Remove the pieces of wood molding. The door is secured to the casting of small nails. Raise the molding from the door by inserting the tip of a crowbar and formatting the door and wonder of the molding from the door. Tighten the clips to the bedroom door of the trap to release the net. Lay out the door to new nets. Align the top of the net and the top of the door to the bedroom straight. Staple one side of the net to the edge of the door to the garage.
Pull down the web, the other side of the garage door screens retractable, the net taut. Staple on this side of the net on the edge of the door. Staple the mesh of the door frame. Cut off the excess mesh with a utility knife. Remove the clips used to secure the side of the net from the edge of the door handle. Attach the molding pieces over the edges of the mesh. Engine finishing nail the molding piece and the door with a hammer. Place the top of the door at the top of the track on the threshold.
Take the garage door screens retractable off its tracks jus like wood door frame. Place the door on a flat surface, the inner door upwards. Remove the rubber spline grooves along the inner edges of the door. The spline keeps the rubber strip along the grid lines just inside the edges of the door. Pull out the spline grooves of the needle. – Pliers to release the nets. Cut a new long-spline, which is equal to the length of the old spline with a utility knife.